• Sourcing Solutions
  • Services & Membership
  • Help & Community
13mm*80mm aluminum injection packer

13mm*80mm aluminum injection packer

Shared by: Sarai Christiandom from ALIEXPRESS
  • Reference Price:
    US $0.26 / piece
  • Package Size:
    32cm x 28cm x 10cm (12.60in x 11.02in x 3.94in)
  • Type:
  • Package weight:
    0.024kg (0.05lb.)
  • length:
  • Diameter:
  • Material:
  • connection:
  • Brand Name:
  • Model Number:
  • Unit Type:
  • weight:
  • Shape:
View full details
Over 102 suppliers can give you a quotation.
Get Quotations Now
You should get the quotation(s) in 4 hours .

13mm*80mm aluminuminjection packer


1. The injection packer is with strict quality control.

2. It is widely used in building construction concrete crack and water leaking stop.

3. Long size injection packer is used on lose structure; short size on compact structure.

4. It suits for polyurethane resin and epoxy resin.

Method of Construction for Injection

1. Crack and leakage condition inspection. Check the process procedure after finding the thickness width and depth of crack and leakage condition of the structure.

2. Drilling Operation Drill directly into crack section if the thickness of concrete is thinner than 10cm. For the thickness of 10~50cm drill it with 45 degree angle by keeping a distance of 1/5 of concrete thickness. Make sure it penetrates the crack section. If the thickness is over than 50cm keep the distance of 20~30cm and drill it with 45 degree angle until it penetrates crack section. And keep drilling by maintaining the fixed interval. (5 holes within 1 meter. Drill it in zigzags).

3. Packer Installation Clean the inside of drilled holes with compressor. Make sure that rubber sleeve of packer and cutting line of tightening nut should be put into the inside of concrete surface when installing. Tighten the packer completely by using the T-box. (Packer might be damaged if you tighten it too strongly).

4. Injection Operation Inject the waters stopping material by using the high pressure device or grease gun. Maintain the initial injection pressure as around 40kg/cm and increase the pressure by each 10kg/cm gradually until the water stopping material flows out from crack section. Water will come out from the crack section first and then water stopping foaming agent and then water stopping liquid at last. If the water stopping material that is not foamed comes from the crack section then move to next packer for injection.

5. Packer Removing Operation Remove and break the packer by using vise pliers or hammer as a tool. If there is still a wet section then inject the water stopping material again.

6. Finishing Operation Remove the water stopping material that is remained on the crack section. Spreading with the elastic sealing material.

Contact Person:Amy Lu



Notice:The articles, pictures, news, opinions, videos, or information posted on this webpage (excluding all intellectual properties owned by Alibaba Group in this webpage) are uploaded by registered members of Alibaba. If you are suspect of any unauthorized use of your intellectual property rights on this webpage, please report it to us at the following:ali-guide@service.alibaba.com.